Category Acura TPMS Reset

Acura TPMS Reset Procedure

acura tpms

Post Content

 TIRE PRESSURE MONITORING SYSTEM RESET PROCEDURE

Acura 2004-2009 all models

Reset after tire rotation, flat repair or after sensor replacement

After rotating the tires, repairing a flat tire or replacing a TPMS sensor, drive the vehicle for at least 40 seconds at a speed of 15 mph (24 km/h) or more, and all the sensor ID’s will be memorized automatically.

If indicator does not go out, further diagnosis is required.

Acura 2010 All Models

Reset after tire rotation, flat repair or after sensor replacement

After rotating the tires, repairing a flat tire or replacing a TPMS sensor, drive the vehicle for at least 40 seconds at a speed of 15 mph (24 km/h) or more, and all the sensor ID’s will be memorized automatically.

Each sensor is an integrated unit made up of the tire valve stem, a pressure sensor, and a transmitter. The unit is attached to the inside of the wheel, around the valve stem. The sensor transmits internal tire information one time per 60 seconds to the TPMS control unit. When the TPMS control unit receives a tire pressure reading of less than: With 17 inch and 18 inch wheels 175 kPa (1.8 kgf/cm2, 25 psi), or with 19 inch wheels front 202 kPa (2.1 kgf/cm2, 29 psi), rear 175 kPa (1.8 kgf/cm2, 25 psi), the TPMS control unit then turns on the low tire pressure indicator and the appropriate tire(s) indicator. When that tire’s pressure is increased to more than: With 17 inch and 18 inch wheels 200 kPa (2.0 kgf/cm2, 29 psi), or with 19 inch wheels front 235 kPa (2.4 kgf/cm2, 34 psi), rear 200 kPa (2.0 kgf/cm2, 29 psi), the transmitter sends the tire pressure reading to the TPMS control unit, and the TPMS control unit turns the indicators off.

If indicator does not go out, further diagnosis is required.


 

Acura ZDX TPMS Reset

Acura ZDX TPMS Reset

Post Content

Acura ZDX TPMS Reset

 

  1. Ensure all tires are inflated to the pressure listed on the tire placard.
  2. Drive vehicle at speeds above 15 mph for a minimum of 40 seconds.
  3. Sensor ID’s will be learned automatically