BMW F06 F12 F13 M6 coupé TPMS Reset Guide

BMW F06 F12 F13 M6 coupé TPMS Reset Guide

BMW F06 F12 F13 M6 coupé  TPMS Tire Pressure Monitoring System Reset Guide

Illuminated: the Tire Pressure Monitor signals a loss of tire inflation pressurein a tire. Reduce your speed and stop cautiously. Avoid sudden braking and steering maneuvers. Flashing and then continuously illuminated: no flat tire or loss of tire inflation pressure can be detected.
▷ Interference through systems or devices
with the same radio frequency: after leav‐
ing the area of the interference, the system
automatically becomes active again.
▷ TPM could not conclude the reset: perform
the reset of the system again.
▷ A wheel without TPM electronics is fitted:
have the service center check it if needed.
▷ Malfunction: have the system checked by
your service center

Reset the system after each adjustment of the
tire inflation pressure and after every tire or
wheel change.
On the Control Display and on the vehicle:
1. “Vehicle info”
2. “Vehicle status”
3.
  “Perform reset”
4. Start the engine – do not drive off.
5. Reset tire inflation pressure:”Perform
reset”.
6. Drive away.

The tires are shown in gray and the status is
displayed.
After driving faster than 19 mph/30 km/h for a
short period, the set tire inflation pressures are
accepted as reference values. The reset is
completed automatically while driving.
After a successfully completed Reset, the
wheels on the Control Display are shown in
green and “Tire Pressure Monitor (TPM)
active” is displayed.
You may interrupt this trip at any time. When
you continue the reset resumes automatically.

Leave a Reply

Your email address will not be published. Required fields are marked *